BACKPACKING with Dave
  CAMPING with Dave
  CLIMBING with Mike
  DRIVING with Steve
  GOLFING with John
  HIKING with Dave
  LANDSCAPING with John
  RUNNING with Dave
  TRAVEL with John
   
  Beginner's Guide to Climbing
 
  Beginner's Guide to Climbing
Rock Climbing Gear
Mike's Climbing Emails
All About Mike

Sport Climbing Safety

Climbing Safetywhich is like saying "boring 4 hour lecture." Just the thought of it makes you yawn, so I'll try and make this entertaining.

by Mike

SPORT CLIMBING — The novice climber’s fear is usually that of falling. Bolts provide the beginning climber with a sense of security. If placed properly, the bolt will hold several tons of force. That’s much, much more than a falling climber could ever generate. However, it is up to the sport climber to inspect that each bolt was properly placed before trusting it to hold a fall. Assume nothing.

Check it out
There are many ways to test a bolt placement. You can tap around the bolt to see if it sounds tight or hollow. Or try pulling on it. But never put your finger inside the hole of the hanger. Instead, grasp the bolt with two fingers and give it a jiggle. This will let you know if the hanger is sitting flush with the rock. If it doesn’t feel right, don’t trust it.

Believe it or not
The longer you climb the more you’ll find interesting bolt placements. One of the most unnerving is the dreaded “swinger” bolt. This happens when the bolt was not drilled deep enough in the rock before the bolt was tightened down. When you grab a swinger with two fingers and wiggle it, the hanger will spin around like a Ferris wheel. The bolt may hold a fall, but you just never know.

The best thing?
Find a way to protect around it. Or you can ‘clip it and skip it,’ where you explain to yourself that although you’re protected by the bolt, you pretend like you aren’t. Better yet, put a Yates Screamer on the bolt. This will cut down on the force applied to that substandard bolt in the event of a fall.

Button, button
Another bolt occasionally found is the quarter inch button head bolt. This is an old type of bolt found on some older routes. A hole is drilled into the rock, and a ¼ inch wide bolt is inserted through a hanger and then hammered into the hole. You will recognize this bolt because there isn’t a head to tighten down, just a deadly round knob. This type of ancient bolt will probably not hold a substantial fall and should not be trusted.

Bolts provide the beginning climber with a safe way of protecting a fall on a cliff face. Proper safety instruction is critical to learn before casting off on a rock climb. Be safe and not sorry by learning how to clip bolts, thread the chains and how to back yourself up with simple knots at the belay stations. Rock climbing can be a potentially dangerous yet very rewarding sport. Be safe and learn the “ropes” before you go.

< Prev | 1 | 2 | 3 | 4 | 5 | 6 | 7 | Next >

Sport Climbing
Beginner's Guide to Rock Climbing
All Rock Climbing Articles

 

MORE CLIMBING ARTICLES

Sport Climbing
Sport Climbing Tips
Sport Climbing vs Gym Climbing
Traditional Climbing vs Sport Climbing
What is a Climbing Bolt?
Climbing Bolts - a Troubled Past
Falling with Style

Beginner's Guide to Rock Climbing
New Climbers Start Here
Rock Climbing Gear Checklist
Rock Climbing Ratings
Indoor Rock Climbing
Top 10 Rock Climbing Tips
Aid Climbing
Buying Rock Climbing Shoes
Bouldering

Outdoors Home | About | Contact | Privacy | Site Map | Search

 

   
  The Outdoors Newsletter
  Outdoor Basics
  The Outdoor Directory
  Website Utilities